Fysic FW15 Manuel D'utilisation page 25

3. Assembly
1. Install the lower tube (9) with the holes at the top on the base (12) with the screw M10x80 (16),
2 pieces of washers M8xØ20 (21) and the nut M10 (23). Use the wrench (13) and hexagonal
wrenches to tighten the screws. Do not fully tighten the screws yet.
2. Install the arched tube (4) on the base (12) with the screw M10x80 (16), 2 pieces of washers
M8xØ20 (21) and the nut M10 (23). Use the wrench (13) and hexagonal wrenches to tighten the
screws. Do not fully tighten the screws yet.
1
3. Install the connecting tube (5) to the arched tube (4) with the screw M8x35 (18), 2 pieces of washers
M8xØ16 (20) and the nut M8 (22). Use the wrench (13) and hexagonal wrenches to tighten the
screws. Do not fully tighten the screws yet.
4. Assemble the connecting tube (5) to the lower tube (9) with the bolt (6). The height of the FW15
trainer can be adjusted by securing the tube in another place in the lower tube.
3
5. Install the upper tube (8) to the lower tube (9) with 4 pieces of screws M8x12 (17), 8 pieces of
washers M8xØ16 (20) and 4 pieces of nuts M8 (22). Tighten everything first by hand.
Use the wrench (13) and hexagonal wrenches to fully tighten the screws.
6. Fix the upper tube (8) to the arched tube (4) using the 2 tightening screws (3).
5
2
4
6
24