Selecting The Battery Type (Lipo/Lihv) - VOLTCRAFT V-CHARGE ECO 6X 1S Notice D'emploi

10. Selecting the battery type (LiPo/LiHV)

• Press and hold the power button (8) for around 3 seconds until
"A–P" or "A–H" appears on the display; "P" (LiPo battery) or "H"
(LiHV battery) flashes.
• To switch between "A–P" and "A–H", press and hold the power
button for around 3 seconds.
"A–P" = all 6 charging channels are set to battery type "LiPo"
"A–H" = all 6 charging channels are set to battery type "LiHV"
If no button is pressed for around 3 seconds, the charger
saves the current setting and exits the programming
mode.
• The battery type for each charging channel may be set sepa-
rately (e.g. charging channel 1+2 = "LiPo", charging channel
3+4+5+6 = "LiHV").
From the display "A–P" or "A–H" (see above), press the power
button (8) briefly several times. "1–P", "2–P", "3–P", "4–P",
"5–P", "6–P", or "1–H", "2–H", "3–H", "4–H", "5–H", "6–H" ap-
pears on the display in succession. The number represents the
charging channel and "P" or "H" the battery type.
"1–P", "2–P", "3–P", "4–P", "5–P", "6–P" = set the individual
charging channel to battery type "LiPo".
"1–H", "2–H", "3–H", "4–H", "5–H", "6–H" = set the individual
charging channel to battery type "LiHV".
• If no button is pressed for around 3 seconds, the settings are
saved, the charger beeps twice and the setting mode is termi-
nated automatically. The currently set charging current appears
54