Starting/Ending Charging - VOLTCRAFT V-CHARGE ECO 6X 1S Notice D'emploi

11. Starting/ending charging

• Firstly, set the charging current, then the battery type as outlined
in the sections above.
• Connect a 1-cell LiPo or LiHV battery to the corresponding
charging channel. If the charger has detected the battery, it
beeps.
Attention!
Only one battery may be connected to each charging
channel. Never use more than one charging connection
(MICRO, MX, mCPX) per charging channel at the same
time. This will lead to a fault in the charger and void the
warranty!
When connecting, note the correct polarity of the battery
and charging channel socket; the polarity is indicated on
the socket (red battery cable = plus/+, black battery ca-
ble = minus/-).
It must also be ensured that the battery type setting
("LiPo" or "LiHV") on the charger matches the battery
model.
• The charging process commences automatically. The corre-
sponding LED indicator for the charging channel flashes red
during charging.
When charging a LiHV battery, the LED indicator flashes
faster than for a LiPo battery.
56