Parkside PGKGA 40-Li A1 Traduction Des Instructions D'origine page 60

GB GB IE IE
Filling with chain oil:
• Check the oil level indicator on the oil
tank ( 39) regularly and top-up the
oil if the minimum mark „MIN" (
is reached on the oil level indicator. The
oil tank holds about 120 ml of oil.
• Use bio-oil containing additives to redu-
ce friction and wear. You can order this
from our service centre.
Alternatively, use chain lubricating oil
with a low proportion of adhesion addi-
tives.
• Empty the oil tank if it will not be used for
a prolonged period of time (6-8 weeks).
1. Unscrew the oil tank cap (41) and pour
the chain oil into the tank.
2. Wipe away any spilt oil and close the
oil tank cap (41).
3. You can regulate the oil flow with the
adjusting screw (42).
Always turn off the device
and let the motor cool down
before filling with chain oil.
Overflowing oil can cause a
fire.
Swivelling Out the
Blade Beam
The blade bar must be checked
regularly for wear and reground. A
blunt blade bar causes the device
to overload. Any damage that re-
sults is not covered by the warranty.
1. Hold the safety blade beam on the
handle to adjust the blade beam (43).
2. Unlock the safety lever (44) and keep
it pressed.
3. By simultaneously exerting pressure on
the lock lever (45), you will loosen the
fixation of the cutter bar.
60
4. The safety blade beam can now be
swivelled out. Use the stop stages and
allow the stop lever (45) to click back
40) in. You can choose 7 stop stages.
5. Then, release the safety lever (44)
again and ensure that it latches back
into its initial position.
Pivoting the pole-
mounted pruner
1. Pull the lock (46) outward and turn it
90°.
2. Hold the pole-mounted pruner at the
protective transport (9) and turn it to
the desired position.
There are five possible positions.
3. Fix the pole-mounted pruner by pulling
the lock (46) outward and turning it
90° back to the original position.
Putting on the carrying
harness
The body protection (20) on
the carrying harness must
be placed between the body
and the device.
Always wear the carrying
harness when working with
the 3-tooth blade! Always
turn the device off before
taking off the carrying har-
ness. Accident hazard.
Generally, we recommend using the
carrying harness whenever using
the device.
The carrying harness is
equipped with a quick-relea-
se device. Pulling the tab (47)