Publicité
Les langues disponibles
Les langues disponibles
hands and away from your body.
Before switching the apparatus on,
make sure that it is not touching
any objects.
1. Turn the device on using the on/off
switch (28). The charge status indicator
(27) lights up as long as the device is
switched on.
2. To start, press and hold the safety
switch (29) while pressing the start
switch (30). The hedge trimmer runs at
top speed. You can release the safety
switch (29) again.
3. To switch it off, release the start switch
(30).
4. Turn the device off using the on/off
switch (28).
Working with the hedge
trimmer
While cutting, make sure that you
do not touch any objects, such as
wire fences or plant supports. This
can cause damage to the cutter bar.
•
To avoid eye injuries, always wear
safety goggles while working with the
hedge trimmer.
•
Always hold the device tightly with
both hands, with one hand on the rear
handle and the other hand on the front
round handle (
Your thumb and fingers must tightly
clasp the handles.
•
Check the carrying harness (
comfortable positioning which facilita-
tes holding the hedge trimmer.
•
If the blades become jammed with
solid objects, switch the device off
immediately, pull the mains plug, and
remove the object.
•
Avoid over-stressing the device while
working.
5).
A
19) for
A
Working with the pole-
mounted pruner
If the saw chain gets stuck,
do not attempt to pull out the
pruner with force. There is a
risk of injury. Turn the motor
off and use a lever arm or
wedge to release the pruner.
• The saw chain should have reached it ma-
ximum speed before you begin sawing.
• You will have better control over the
device if you saw using the lower edge
of the blade bar (saw chain in pulling
direction) and not using the upper edge
of the blade bar (saw chain in pushing
direction).
• The saw chain must not touch the
ground or any object while sawing
through the material or thereafter.
• Ensure that the saw chain does not get
stuck while sawing. The log must not
break or splinter.
• Please also observe the precautionary
measures to protect against kickback
(see the safety information).
• Remove branches hanging downwards
by sawing from the top of the branch.
• Twisted branches must be individually
cut down to size.
Working using the thread
spool
•
In small grass areas hold the device at
an angle of about 30° and swing the
cutting head evenly to the right and
left with a semi-circular movement.
•
The best results are obtained with a
maximum grass length of 15 cm. If the
grass is taller, it is recommended to
GB
IE
63
Publicité
