Publicité
Les langues disponibles
Les langues disponibles
Assembly
Remove the battery from the
device before carrying out
any work on the device.
Only use original parts.
The device can be used with either
the hedge trimmer, pole-mounted
pruner or trimmer attachment,
either with spool or 3-tooth blade.
Dismantling is carried out in reverse
order.
Remove/insert battery
1. To remove the battery (25) from the
device, press the release button on the
battery and pull the battery out.
2. To insert the battery (25), push the
battery along the guide rail into the
device. You will hear it click into place.
Only insert the rechargeable
batteries once the device is
completely assembled. Risk
of injury!
Mounting the tubular
B
shaft
Before mounting, remove the
protective cap(s) from the front tu-
bular shaft (2).
1. Loosen the butterfly screw (3).
2. Pull the lock (8) outward and turn it left
or right as far as it goes.
3. Slide the front tubular shaft (2) onto the
tubular shaft on the device housing (4).
4. Pull the lock (8) outward and turn it
back to its original position.
5. Turn the front tubular shaft (2) with a
gentle rotating movement until the lock
(8) clicks into place in the bore on the
front tubular shaft (2).
6. Fix the tubular shaft in place with the
butterfly screw (3).
Only tighten the butterfly
screw (3) finger-tight. The use
of maximum manual force
will damage the tubular shaft.
Mounting the round
C
handle
The round handle must be
mounted with a spacing of
at least 25 cm to the device
handle!
The leg protection must al-
ways be mounted on the
operator side!
1. Place the round handle (5) onto the
tubular shaft of the device housing (4).
Choose a position within the
levelled adjustment range mar-
ked on the bottom of the tubu-
lar shaft.
2. Position the leg protection (7) onto the
round handle (5) from below.
3. Fix the round handle (5) and the leg
protection (7) with the four hexagon
socket screws (32) using the hexagon
socket wrench (21) from the
storage (
31).
A
Mounting the saw chain
Pay attention to the correct rotation
direction of the saw chain. This is
indicated on the chain wheel cover
(33) and above the bar bolt (37).
GB
IE
57
Publicité
