Tunturi 23TCR20000 Manuel De L'utilisateur page 16

English
- Make sure that only one person uses the equipment at a time�
The equipment must not be used by persons weighing more than
150kg (330 lbs)��
- Do not open equipment without consulting your dealer�
Assembly instructions
Description illustration A
The illustration shows what the trainer will looks like after the
assembly is completed�
You can use this as a reference during your assembly, but do follow
the assembly steps always in the correct sequence as showed in the
illustrations�
Description illustration B
The illustration shows what components and parts you should find
when un-boxing your product�
NOTE
• Small parts can be hidden/ packed in hollow spaces in the
Styrofoam product protection
• If a part is missing, contact your dealer�
Description illustration C
The illustration shows the hardware kit that comes with your product�
The hardware kit contains bolts, washers, screws , nuts etc� and the
required tools to properly fit your trainer�
Description illustration D
The illustrations shows you in the correct following order how to
assembly your trainer best�
WARNING
• Assemble the equipment in the given order�
• Carry and move the equipment with at least two persons�
CAUTION
• Place the equipment on a firm, level surface�
• Place the equipment on a protective base to prevent damage to
the floor surface�
• Allow at least 100 cm of clearance around the equipment�
• Refer to the illustrations for the correct assembly of the
equipment�
Additional assembly information
Additional information to Assembly step D-3 & D-4
- Set the tension adjustment knob to the lowest (1) tension setting
level�
- Connect the sensor wire cable (black plastic connectors), taking
note of the correct orientation so the locking system will be
effective�
- Hook up the steel cable rod end coming from the bottom of the
upright tube onto the hook from the steel cable coming from the
main frame�
- Pull the outer steel cable from the upright tube cable and fit the
brass ending into the bracket on the cable end coming from the
main frame�
- Place the upright tube over the main frame fixing bracket, in where
the fixing bolts are pre-assembled and stay pre-assembled�
( While lowering the upright tube, gently pull the upper part of the
cable up, to avoid the cable get caught by the connection� )
- The upright tube should automatically find the centre position, but
it is advisable to make the slightest correction needed to make sure
the position is good�
- The perfect position is when the fixing bolts are perfectly centred in
line with the upright tube holes�
NOTE
• Avoid the cable connection between these two parts get
pinched�
• By fastening the two bolts (turning in clockwise direction) on the
front side you will widen the fixing bracket so the upright gets
fixed firmly�
- To fix the upright tube firmly it is needed to tighten the bolt on the
upper side first firmly�
- After fixing the upper bold, you need to fix the lower bold firmly�
- By fixing the lower bold, the upright tube will be repositioned
slightly resulting that the upper bold can be fixed a little more,
therefore it is needed to fix the upper bolt again�
- Repeat these steps until both bolts are firmly fixed to ensure the
upright tube fixation well�
NOTE
• Save the tools provided with this product, after you completed
the product assembly,
for future service purposes�
Additional information
Packaging disposal
Government guidelines ask that we reduce the amount of waste
material disposed of in land fill sites� We therefore ask that you
dispose of all packaging waste responsibly at public recycling centres�
End of life disposal
We at Tunturi hope you enjoy many years of enjoyable use from your
fitness trainer� However, a time will come when your fitness trainer will
come to the end of its useful life� Under 'European WEEE Legislation
you are responsible for the appropriate disposal of your fitness trainer
to a recognised public collection facility�
Workouts
The workout must be suitably light, but of long duration� Aerobic
exercise is based on improving the body's maximum oxygen uptake,
which in turn improves endurance and fitness� You should perspire,
but you should not get out of breath during the workout�
To reach and maintain a basic fitness level, exercise at least three
times a week, 30 minutes at a time� Increase the number of exercise
sessions to improve your fitness level�
It is worthwhile to combine regular exercise with a healthy diet� A
person committed to dieting should exercise daily, at first 30 minutes
or less at a time, gradually increasing the daily workout time to one
hour� Start your workout at low speed and low resistance to prevent
the cardiovascular system from being subjected to excessive strain�
As the fitness level improves, speed and resistance can be increased
gradually� The efficiency of your exercise can be measured by
monitoring your heart rate and your pulse rate�
Exercise Instructions
Using your fitness trainer will provide you with several benefits, it will
improve your physical fitness, tone muscle and in conjunction with a
calorie controlled diet help you lose weight�
1 6