Uninstalling The Seat - Britax MARATHON CLICKTIGHT Guide D'utilisation

BRITAX Child Safety, Inc.
Overhang
It is important that the base of the child seat rests completely
flat on the vehicle seat with no side overhang. As seen
in the illustration, it is
permissible to allow up to
7.6 cm (3 in.) of the base
to hang over the front
edge of the vehicle seat.
If the vehicle seat does
not allow enough of the
child seat base to make
contact, adjust the recline
angle to a more upright
position. Not doing so
could cause the child seat
to not perform as intended.
In some cases, the vehicle head
restraint can prevent the child
seat head pad from being raised
high enough to properly adjust the
harness for the fit of your child when
using a forward facing reclined
position. DO NOT force the child
seat head pad past the vehicle head
restraint. Doing so could cause the child seat not to
perform as intended. If the location of the vehicle head
restraint interferes with the child seat head pad, raise
or remove the vehicle head restraint. If the vehicle head
restraint cannot be removed, move the child seat to the
upright position or try a different seating location.

Uninstalling the Seat

1. Unbuckle the vehicle seat
belt.
NOTE: For car seats
installed with lower
connectors, see page 29.
2. Open the CLICKTIGHT.
26
arathon CT CAN.indb 26
7.6 cm
Acceptable
Forward-Facing
7.6 cm
Acceptable
Rear-Facing
2/20/2018 11:28:36 AM