CAME BX704AGS Manuel D'installation page 56

Slowdown sensitivity
Adjust the obstruction detection sensitivity during slowdown in percentage terms.
This function appears only if the [F11 - Encoder] function is active.
F35
Adjusting the partial opening
Set the partial-opening percentage for the gate.
This function appears only if the [F11 - Encoder] function is active.
F36
Opening slowdown point
Set the percentage of the total travel to be used for slowdown during gate opening.
This function appears only if the [F11 - Encoder] function is active.
F37
Closing slowdown point
Set the percentage of the total travel to be used for slowdown during gate closing.
This function appears only if the [F11 - Encoder] function is active.
F38
Manoeuvre thrust activation
Adjust the thrust torque increase during opening and closing.
F48
RSE communication
Configure the function performed by the board connected to the RSE connector.
F49
Save data
Save user data, timings and configurations to the memory device (memory roll).
The function is displayed only when a memory roll card is inserted into the control board.
F50
Read data
Upload user data, timings and configurations to the memory device (memory roll).
The function is displayed only when a memory roll card is inserted into the control board.
F51
10% to 100% (Default 100%)
10% = minimum thrust and high obstruction sensitivity
100 % =maximum thrust and low obstruction sensitivity
10% to 80% (Default 20%)
5% to 30% (Default 25%)
5% to 30% (Default 25%)
OFF (Default)
ON
OFF (Default)
1 = Paired
3 = CRP
OFF (Default)
ON (Run operation)
OFF (Default)
ON (Run operation)