CAME BX704AGS Manuel D'installation page 53

PROGRAMMING
Programming button functions
1
Getting started
Once the electrical connections have been made, proceed with commissioning. Only skilled and qualified staff may perform this operation.
Make sure that there are no obstacles in the way.
Power up the device and begin programming.
Start programming with the functions indicated below.
F54 Opening direction
F1 Total stop
A3 Travel calibration
After powering up the system, the first manoeuvre is always to open the gate Wait for the manoeuvre to be completed.
Press the ESC button or STOP button immediately in the event of any faults, malfunctions, strange noises or vibrations, or unexpected behaviour in the
system.
If the three display segments are flashing, calibrate the travel.
Functions menu
Total stop
Activate or deactivate input 2-1. If it is activated, the input is used as a normally closed contact.
With the input open, this function excludes all commands, including any automatic closing.
F1
CX input, CY input
Associate a function with the input CX CY
F2
F3
The ESC button is used to perform the operations described below.
Exit the menu
Delete the changes
Go back to the previous screen
Stop the operator
The <> buttons are used to perform the operations described below.
Navigate the menu
Increase or decrease values
Open or close the operator
2 3
The ENTER button is used to perform the operations described below.
Access menus
Confirm choice
OFF (Default)
ON
OFF (Default)
C1 = Reopen while closing (photocells)
C2 = Reclose while opening (photocells)
C3 = Partial stop Only with [Automatic close] activated.
C4 = Obstacle standby (photocells)
C7 = Reopen while closing (sensitive edges)
C8 = Reclose while opening (sensitive edges)
r7 = Reopen while closing (sensitive edge with 8K2 resistor)
r8 = Reopen while opening (sensitive edge with 8K2 resistor)
1 ESC button
2 < > buttons
ENTER button
3