Publicité
FRONT BRAKE AND REAR BRAKE
5 - 23
4. Install:
Pin 1
Plain washer 2
Cotter pin 3
NOTE:
After installing, check the brake pedal height.
Refer to "REAR BRAKE ADJUSTMENT" sec-
tion in the CHAPTER 3.
Front brake hose
1. Install:
Brake hose 1
10 Nm (1.0 m · kg, 7.2 ft · lb)
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
pass the brake hose in front of the axle boss
a, then fit it into the hose groove b so that the
brake hose does not contact the nut (wheel
axle).
2. Install:
Hose cover 1
Plain washer 2
Bolt [hose cover (M8)] 3
16 Nm (1.6 m · kg, 11 ft · lb)
Bolt [hose cover (M6)] 4
7 Nm (0.7 m · kg, 5.1 ft · lb)
3. Pass the brake hose through the cable
guide 1, then through the guide a on
the protector 2.
CHAS
New
Publicité
