Publicité
EC240000
CABLE ROUTING DIAGRAM
1 Hose guide
2 Brake hose
3 Fuel tank breather hose
4 Oil tank breather hose
5 Clamp
6 "ENGINE STOP" button lead
7 Sub wire harness
8 TPS (throttle position
sensor) lead
9 Neutral switch lead
0 Oil hose
A Hose holder
B CDI magneto lead
C Clutch cable
D Cylinder head breather hose
E Carburetor breather hose
F Overflow hose
CABLE ROUTING DIAGRAM
Å Pass the clutch cable through
the cable guide.
ı Pass the fuel tank breather hose
between the handlebar and ten-
sion bar, then insert its end into
the hole of the number plate.
Ç Pass the decompression cable
and "ENGINE STOP" button
lead under the frame.
Î Fasten the CDI magneto lead,
neutral
switch
"ENGINE STOP" button lead to
the frame with a plastic locking
tie and cut off the tie end.
‰ Pass the "ENGINE STOP" but-
ton lead along the inner side of
the oil tank breather hose.
2 - 21
Ï Fasten the sub wire harness
and "ENGINE STOP" button
lead to the frame in front of the
protector of the sub wire har-
ness with a plastic locking tie
and cut off the tie end.
Ì Pass the cylinder head breather
hose along the right side of the
oil tank breather hose.
Ó Pass the sub wire harness
lead
and
between the engine brackets.
È Fasten the sub wire harness
and "ENGINE STOP" button
lead to the frame at the rear of
the protector of the sub wire har-
ness with a plastic locking tie
and cut off the tie end.
SPEC
Publicité
