Auriol 4-LD6162-1-2 Utilisation Et Avertissements De Sécurite page 18

 Press the SET button (25) to confirm the
setting.
 Set
the position of D (day)/M (month) M
(month)/<->D (day), the month, the day, the
time zone 00 - (-)12, the hours, the minutes,
the 12-/24-hour time format in the same way,
the language of the weekday display
(ENG=English, FRE=French, GER=German,
SPA=Spanish, DUT=Dutch, DAN=Danish,
ITA=Italian, RUS=Russian) and the radio
reception ON/OFF.
 Confirm your setting by pressing the SET
button (25). To return to the normal time
display.
Adjusting the time zone
If you are in a country where the current time
differs from the DCF77 radio signal, use the time
zone adjustment to use your device in a time zone
other than the standard-setting (UTC + 1 = Central
European Time).
 Set the difference in hours (e.g., -01) to the
desired time zone.
 Press the SET button (25) 1 x long and then 4
x short in normal time display. The time zone
flashes and can be set with the up button (26)
and the down button (27).
 Press the SET button (25) to confirm the
setting.
 Press the SET button (25) repeatedly until you
return to the normal time display.
12/24-hour time format
 Press the down button (27) in the normal time
display. The 12- or 24-hour time format
flashes and can be adjusted with the up button
(26) and the down button (27).
In the 12-hour time format, the display shows
AM in the morning and PM in the afternoon.
Switch on/dim display illumination
For continuous display illumination, the plug-in
power supply must be connected to the hollow
plug socket (37)
power source.
Battery operation:
Press the SNOOZE/LIGHT button (8) to turn on
the display illumination for about 5 seconds.
Mains operation:
Press the SNOOZE/LIGHT button (8) to choose
between high, low or no display illumination.
Alarm
Setting the alarm
The device has 2 separately adjustable alarm
times.
 In the normal time display, briefly press the
SET button(25) to select Alarm1
.
A2 A2 A2 A2
 When Alarm 1 or Alarm 2
A1 A1 A1 A1
press and hold the SET button (25) for
approx. 3 seconds to switch to the setting
mode.
The hours flash on the display.
 Set the hours by pressing the up button (26)
and the down button (27).
 Confirm the setting by pressing the SET button
(25).
 Set the minutes in the same way.
 Confirm your setting by pressing the SET
button (25). To return to the normal time
display.
- 16 -
and to an external
or Alarm2
A1 A1 A1 A1
is displayed,
A2 A2 A2 A2