Auriol 4-LD6162-1-2 Utilisation Et Avertissements De Sécurite page 16

Starting up the device
First insert the batteries into the battery
compartment of the outdoor sensor
(46) and only then into the battery
compartment of the device (35).
Remove the protective film from the device

and the external sensor.
Open the battery compartment of the

outdoor sensor (46).
Insert the supplied batteries with the correct

polarity.
The control LED (47) lights up temporarily
and the outside temperature (48) and
outside humidity (40) are displayed.
Close the battery compartment (46).

Open the battery compartment of the device

(35).
Insert the supplied batteries with the correct

polarity.
The display is briefly displayed in its entirety.
A beep sounds and the room temperature
(11) and humidity (13) are displayed.
Close the battery compartment (35).

The display (1) is temporarily displayed in
its entirety, then the weather symbol flashes
briefly – slightly cloudy. As a result, the
radio waves of the outdoor sensor/channel
display (5) flash and the device
receives the data of the outdoor sensor. This
process can take a few minutes. If the
reception is successful, the selected channel
CH 1, 2 or 3 is displayed in the outdoor
sensor/channel display (5). The current
outside temperature (7) and the current
outside humidity (9) appear on the display.
After the external sensor has been
successfully received, the device will start
receiving the DCF77 radio signal and the
radio symbol (14)
display. This process can take 3-10 minutes.
During reception, all buttons except the
SNOOZE/LIGHT button (8) and the radio
reception button (32) have no function and
the display lighting is temporarily switched
off. If reception of the time signal is
unsuccessful after 10 minutes, the radio
symbol (14) will go out.
Set the time manually (see "Basic settings").
The unit will receive the radio signal
between 01:00 and 03:00 and start a new
reception attempt at 04:00 and 05:00. The
time is corrected automatically after
successful signal reception.
Note: Please do not move the device or
the outdoor sensor during the reception
process.
If the reception is successful, the
radio symbol (14) appears
permanently and the correct time,
date and day of the week are automatically
set. During daylight saving time, the daylight
saving time display (15)
display.
- 14 -
will flash on the
appears on the