SilverCrest SSJK 300 A1 Mode D'emploi page 37

9.4 Switching on/off and
reverse mode
• To turn on the device, set the on/off
switch 12 to 1.
• To turn off the device, set the on/off
switch 12 to 0.
• If you set the on/off switch 12 to R, you
will start reverse mode. With this func-
tion you can eliminate small blockages.
9.5 Removing blockages
If a piece of fruit or vegetable is blocking the
auger 5, it must be removed immediately.
You can recognise a blockage...
... if no more juice comes out of the
juice outlet 9, even though pieces of
food are still in the food chute 3.
... if the pieces of food in the food
chute 3 no longer slide down,
... if there are unusual sounds, or
... if the motor becomes audibly slower.
Reverse mode
First, try to fix the blockage by using reverse
mode:
1. Set the on/off switch 12 in sequence
to 0, for approx. 2 seconds to R (re-
verse mode) and again to 0.
2. Turn the on/off switch 12 to 1. Check
whether the device is working normally.
3. Repeat the process, if necessary.
Cleaning the device
If this does not resolve the blockage, follow
these steps:
1. Pull out the mains plug 11.
2. Take the device apart (see "Disassem-
bly" on page 35).
3. Clean the auger 5, the holder 7, the
screen assembly 6 and the working
container 8 (see "Cleaning" on
page 35).
4. Reassemble the parts and proceed with
juice extraction.
10. Disassembly
DANGER! Risk of electric
shock!
Pull the mains plug 11 out of the wall
socket before you disassemble and
clean the device.
1. Pull the food pusher 1 off upwards
from the food chute 3.
2. Remove the filling aid 2.
3. Turn the lid 4 anticlockwise until
the point symbol
opened lock symbol
lid 4.
4. Close the drip stopper 10.
5. Pull out upwards the screen assembly 6
complete with the auger 5. While do-
ing this, move these parts somewhat
back and forth to make them easier to
release.
6. Remove the auger 5 from the screen as-
sembly 6.
7. If necessary, remove the holder 7 from
the working container 8.
8. Turn the working container 8 anticlock-
wise until the
opened lock symbol
working container 8.
11. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
Pull the mains plug 11 out of the wall
socket before you disassemble and
clean the device.
WARNING! Risk of material damage!
Do not use any astringent or abrasive
cleaning agents.
•
points to the
. Remove the
mark points to the
. Remove the
GB
35