SilverCrest SSJK 300 A1 Mode D'emploi page 38

After every use
• Clean the device and all accessories
used after each use and remove all food
residues.
• All accessories must be disassembled
and individually cleaned.
Seals
Proceed as follows for the hygienic cleaning
of the seals 18, 19 and 20:
• Figure A: remove the seal 18 from the
drip stopper 10.
• Figure B: take the seal 19 out of the
working container 8.
• Figure C: pull the seal 20 on the un-
derside of the working container 8 out
of the pulp outlet 17.
• The seal 20 remains firmly attached to
the working container 8 and can be
cleaned in the dishwasher or by hand.
• The seals 18 and 19 can be cleaned
either in the dishwasher cutlery basket
or manually.
• Allow the seals to dry completely before
reinstalling.
Base unit
DANGER! Risk of electric
shock!
The following parts must never be im-
mersed in water or other liquids, and
must not be cleaned in the dishwasher:
- the base unit 13 including the power
cable with mains plug 11.
The cleaning brush 14 must not be
cleaned in the dishwasher.
Wipe off the base unit 13 and the power
cable 11, using a lightly moistened cloth.
Dry with a dry cloth.
36 GB
Accessories
The following accessories can be cleaned
both by hand and in the dishwasher:
- Food pusher 1
- Filling aid 2
- Lid 4
- Auger 5
- Screen assembly 6
- Holder 7
- Working container (max. 300 ml) 8
- Juice container (max. 600 ml) 15
- Pulp container (max. 1200 ml) 16
1. Remove food residues with the clean-
ing brush 14. Do not exert a lot of
pressure on the screen surfaces of the
screen assembly 6.
NOTE: chunky remains in the pulp outlet 17
can be easily removed using the rear side of
the cleaning brush 14.
2. Clean the accessories with warm water
and a little detergent. Afterwards, rinse
all parts with clean water.
Or:
Place the accessories in the dishwasher
and/or the small parts in the cutlery
basket.
3. Allow all parts to dry completely before
you put them away or use the device
again.