□
Press the TX button 20 to manually establish the connection.
Reception is established. The temperature and the air humidity are indicated
on the radio-controlled weather station and on the outdoor sensor.
□
Close the battery compartment 22 on the back of the outdoor sensor by sliding the
battery compartment cover 23 in the opposite direction to that indicated by the arrow.
● Temperature alarm
Only one temperature range can be configured for each outdoor sensor. When the outdoor
sensor measures a value below the set temperature range, an alarm sounds on the radio-
controlled weather station.
□
Press the ALERT button 15 .
The temperature alarm is activated and the icon 55 (see Fig. E) is lit.
□
Press and hold the ALERT button 15 for 2 seconds.
The temperature display 49 starts to flash and shows the upper temperature limit.
□
Press or hold the arrow up 13 or arrow down button 14 to set the upper temperature
limit.
□
Press the ALERT button 15 to confirm your selection.
The temperature display 49 continues flashing and shows the set lower
temperature limit.
□
Press or hold the arrow up 13 or arrow down button 14 to set the lower temperature
limit.
□
Press the ALERT button 15 to confirm your selection.
The temperature alarm is set.
As soon as the temperature alarm sounds, you can switch it off by pressing the SNOOZE/
LIGHT button 5 .
● Cold weather warning
The cold weather warning icon 38 starts to blink when the outdoor sensor measures
temperatures between +1 °C and -1 °C.
The cold weather warning icon 38 is displayed constantly when the outdoor sensor meas
ures temperatures of -1.1 °C and below over a longer period.
● Room name
You can assign a room name to each channel.
Operation
GB/IE/NI
19