Publicité
Les langues disponibles
Les langues disponibles
Start-up / Operation
□
Close the battery compartment 9 on the back of the radio-controlled weather station
by sliding the battery compartment cover 10 in the opposite direction to that indicated
by the arrow.
● Automatic signal detection
After inserting the batteries, you have 20 seconds to set the current air pressure 30 and the
weather display 37 .
If you do not set anything, the air pressure and the weather are set automatically.
□
Press the arrow up button 13 or the arrow down button 14 to adjust the air pressure
.
30
□
Press the HISTORY button 17 to confirm your selection.
□
Adapt the weather display 37 to the weather at your location.
□
Press the HISTORY button 17 to confirm your selection.
The radio-controlled weather station now automatically tries to detect the radio signal of the
outdoor sensor and the DCF radio signal. This procedure can take several minutes.
The RF signal icon 57 flashes while the outdoor sensor's signal is being detected (see Fig.
E). The temperature and the air humidity of the outdoor sensor are displayed 49 51 (see
Fig. E). If the synchronisation failed, the RF signal icon 57 goes off.
The DCF signal icon 40 flashes while the DCF radio signal is being detected (see Fig. D).
Only the SNOOZE/LIGHT button 5 and the arrow up button 13 function during this time.
Note: You can cancel the signal detection by pressing and holding the arrow down button
until the DCF signal icon goes off.
14
Once the DCF signal is received, the time 45 , date 42 and weekday 43 are set automati
cally. The DCF signal icon goes off.
During daylight saving time, the DST icon 41 is displayed (see Fig. D).
The time is synchronised daily at 01:00, 02:00 and 03:00 o' clock. Another synchronisation
takes place at 04:00 and 05:00 o' clock.
● Operation
● Basic settings
□
Press and hold the SET button 12 for approx. 3 seconds.
A beep sounds and the first setting can be changed.
14
GB/IE/NI
Publicité
