Publicité
Les langues disponibles
Les langues disponibles
● Start-up
Note: The maximum range between the radio-controlled weather station and the outdoor
sensor is 100 metres. The range might be reduced by obstacles (walls or objects).
Note: Remove all packaging material from the product. Remove all protective films before
first use.
Note: You can install the radio-controlled weather station and the outdoor sensor on a
surface or hang it on a wall using suspension eyes 4 24 .
Note: Ensure sufficient ventilation of the radio-controlled weather station and keep the
ventilation slots free from obstruction 7 .
● Commissioning the outdoor sensor
□
Open the battery compartment 22 on the back of the outdoor sensor by sliding the
battery compartment cover 23 in the direction indicated by the arrow.
□
Remove the spent batteries first (if applicable).
□
Insert two AAA batteries into the battery compartment 22 . Observe the correct polarity
(+/-).
The control LED 25 on the front of the outdoor sensor flashes briefly.
The temperature 61 and the air humidity 60 are displayed.
□
Close the battery compartment 22 on the back of the outdoor sensor by sliding the
battery compartment cover 23 in the opposite direction to that indicated by the arrow.
Note: The control LED 25 flashes once per minute to signal radio transmission.
● Commissioning the radio-controlled weather
station
Note: After inserting the batteries, you have 20 seconds to set the air pressure and the
weather display (see section "Automatic signal detection").
□
Open the battery compartment 9 on the back of the radio-controlled weather station
by opening the battery compartment cover 10 .
□
Remove the spent batteries first (if applicable).
□
Insert two AA batteries into the battery compartment 9 . Observe the correct polarity
(+/-).
A beep sounds once after insertion.
Start-up
GB/IE/NI
13
Publicité
