Auriol 4-LD6303-1 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 18

Operation
□ Press the arrow up button 13 to activate the alarm function.
The respective alarm bell icon is displayed.
□ Press the arrow down button 14 to deactivate the alarm function.
The respective alarm bell icon is no longer displayed.
● Snoozing/switching off the alarm function
The alarm of the alarm function sounds at the set time.
□ Briefly press the SNOOZE/LIGHT button 5 to activate the snooze function.
The snooze icon 48 (see Fig. D) starts to flash and the alarm sounds again
in 5 minutes.
□ Press any button on the back of the radio-controlled weather station.
The alarm function stops.
● Switching the display of the added outdoor
sensors (see Fig. E)
□ Press the CH button 18 .
The channel display 56 shows the channel of the outdoor sensor.
Once you have added the outdoor sensor to the selected channel, the data of the outdoor
sensor is displayed.
● Adding an outdoor sensor
Note: You can connect up to three outdoor sensors to the radio-controlled weather station.
Additional outdoor sensors are available from the order service.
□ Briefly press the CH button 18 .
The radio channel changes. The currently selected channel is indicated in the
channel display icon 56 (see Fig. E).
□ Open the battery compartment 22 on the back of the outdoor sensor by sliding the
battery compartment cover 23 in the direction indicated by the arrow.
□ Use a thin object if necessary.
□ Set the channel selection switch 21 to the same channel.
□ Keep the CH button 18 pressed until the RF signal symbol 57 lights up.
□ Use a thin object if necessary.
18 GB/IE/NI