Publicité
Les langues disponibles
Les langues disponibles
z Before use
Take all parts from the packaging and check whether the device or
„
parts show any damage. If this is the case, do not use the device.
Contact the manufacturer via the indicated service address. Remove
all protective films and other transport packaging. Check that the
delivery is complete.
Always pull the mains plug from the socket before you perform any
„
work at the car & motorcycle battery charger
Before connecting the charger please read the operating instructions
„
for the battery.
In addition, you must adhere to the instructions from the vehicle
„
manufacturer where a battery is continuously connected in the
vehicle. Secure the vehicle, switch the ignition off.
Clean the battery poles. Make sure that the dirt does not come into
„
contact with your eyes.
Make sure that there is sufficient ventilation.
„
PLEASE NOTE: The ambient temperature is measured in the charger.
Hence, for optimum function, make sure the battery exhibits the same
temperature as the environment.
z Using the device
z Connection
PLEASE NOTE:
Always observe the instructions from the vehicle manufacturer or the
battery manufacturer.
Disconnect the negative pole connection cable (black) of the vehicle
„
from the negative pole of the battery first before charging and
trickle charging if the battery is continually connected in the vehicle.
The negative pole of your battery is usually connected to the car
body of the vehicle.
Then disconnect the positive pole connection cable (red) of the
„
vehicle from the positive pole of the battery.
Only then should you connect the "+" pole quick-contact connection
„
terminal (red)
pole of the battery.
Connect the "–" pole quick contact-connection terminal (black)
„
to the "–"-pole of the battery. Connect the mains cable
car & motorcycle battery charger
terminals are connected in reverse, then the reverse polarity symbol
lights up.
2
z Disconnecting
Disconnect the device from the mains current.
„
Disconnect the "–" pole quick-contact connection terminal (black)
„
from the "–" pole of the battery.
Disconnect the "+" pole quick contact-connection terminal (red)
„
from the "+" pole of the battery.
Reconnect the positive pole connection cable of the battery to the
„
positive pole of the battery.
of the car & motorcycle battery charger to the "+"
13
1
to the socket. If the output
1
GB/IE/NI/CY/MT
.
of the
12
15
14
14
13
Publicité
