Troubleshooting; Technical Data - Cleanmaxx 08337 Mode D'emploi

Troubleshooting

If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps below, contact the customer
service department.
Do not attempt to repair a defective electrical device yourself!
Problem
The handle and
the handlebar do
not fi t together/
the handle does
not lock into
place.
The appliance is
not working. /
The power
LEDs are not
illuminating.
No steam is
released.

Technical data

Model number:
Product number:
Power supply:
Safety class / level:
Water tank capacity:
08337_DE-EN-FR-NL_A5_V4.indb 27 08337_DE-EN-FR-NL_A5_V4.indb 27
27
Potential cause / solution
• It is possible that the cable winder becomes twisted at the
handle during the production process. This prevents the
handle from locking into the handlebar. Turn the cable winder
slightly at the handle until the handlebar fi ts directly into the
opening. When the latch locks into place, the handle has
been securely connected with the handlebar.
• Is the plug properly connected with the socket?
• Is the socket defective? Try another socket.
• Check the fuse for your mains connection.
• Have you pushed the On / Off switch (4) on the front of the
main unit? Please note: The switch on the back (13) is
deactivated when the handle bar (B) has been inserted.
• Has the steam quantity been set high enough? Turn the knob
for the steam quantity (8) control clockwise to increase the
amount of steam.
• The appliance is still not operational. The appliance must heat
up for a few seconds until steam can be emitted.
• The water tank (7) is empty. Fill the water tank (see chapter
"Filling the water tank").
• Has the tank been properly inserted in the main unit (A)?
Check to make sure it is properly seated.
• The nozzle is plugged. Clean the nozzle.
JJ-SC-005B
08337
220–240 V ~ 50 Hz, 1500 W
I, IPX4
max. 350 ml
EN
14.02.2018 14:06:24 14.02.2018 14:06:24