Cleanmaxx 08337 Mode D'emploi page 25

voltage is present. Wait until the appliance has reached the operating temperature
and the power LEDs are blue.
8. Now you can start to clean the fl oor. Push the
the main unit. (The switch on the back (13) has been deactivated when the handle
bar is inserted.) Steam will begin to be emitted from the cleaning head. You can now
increase the quantity of steam by turning the knob for the steam quantity control.
NOTE: After the knob is turned, it will take a few seconds until the respective steam
quantity is reached.
9. Hold the appliance by the handle and tip it slightly towards the fl oor in order to release
it from the upright locking position.
10. Slowly slide the cleaning head back and forth over the fl oor. The fl oor will be cleaned
in the process.
11. When the power LEDs blink red, there is too little water in the tank. Push the
On / Off switch before you fi ll the tank. Before you wash out the fl oor pad or once you
have fi nished cleaning the fl oor, push the
out of the socket. Never pull on the cord, but always on the plug.
12. Wait a few minutes for the appliance to cool off before you remove the fl oor pad.
Be aware that when turning off the appliance a wet area can form beneath the
cleaning head.
13. Follow the instructions in the section "After use".
Use as Handheld Steam Device
WARNING - Danger of Scalding!
■ Never attempt to smooth clothing on people! Hang clothing on a hanger with suffi ci-
ent clearance on all sides so that heat and moisture cannot cause any damage to
any living creatures or objects.
1. Take the handle bar (B) and cleaning head (N) off of the main unit (A) and mount
the nozzle adapter (G) with the desired nozzle on it (see chapter "Assembling the
appliance" and "Functions of the Attachments"). If you would like to steam smooth
fabric, the corresponding microfi ber cloth (M) must be attached to the window
cleanining attachment (D).
2. Fill the water tank (7) (see chapter "Filling the water tank").
4. Insert the mains plug in a properly installed socket that is easily accessible. The
power LEDs (12) behind the water tank will illuminate in red as soon as operating
voltage is present. Wait until the appliance has reached the operating temperature
and the power LEDs are blue.
5. Start cleaning. Push the
steam begins to be emitted from the nozzle. You can now increase the quantity of
steam by turning the knob for the steam quantity control.
08337_DE-EN-FR-NL_A5_V4.indb 25 08337_DE-EN-FR-NL_A5_V4.indb 25
25
On / Off switch and pull the mains plug
3. Turn the knob for the steam quantity control (8) to the
minimum setting by turning it counterclockwise until it
comes to a stop.
On / Off switch (13) on the back of the main unit and
On / Off switch (4) on the front of
EN
14.02.2018 14:06:24 14.02.2018 14:06:24