Beurer BM 54 Mode D'emploi page 28

Low blood pressure
 WARNING
Low blood pressure (hypotension) can be a health hazard and cause dizziness
or fainting. Blood pressure is considered low if systolic and diastolic pressure
are below 90/60 mmHG (source: National Health Service, 2023).
Seek medical attention if you suddenly su er from low blood pressure.
6.5 Displaying and deleting measured values
User
The results of every successful measurement are saved with the date and time.
If there are more than 60 saved measurements, the oldest measurement re-
cords are deleted.
• To clear individual measurements from the relevant user memory, you must
first select a user memory.
• Using the memory button M1 or M2, select the desired user memory (
when the device is switched o .
If you have selected user memory1, the M1 memory button must be
pressed. If you have selected user memory2, the M2 memory button
must be pressed.
Average value
® activated in the display: Measurement data is transferred auto-
Bluetooth
matically.
flashes:
The average value of all this user's saved measured values is displayed.
1. Press M1/M2.
flashes:
The average value of the morning measurements for the last 7 days is displayed
(morning: 5:00–9:00).
2. Press M1/M2.
flashes:
The average value of the evening measurements for the last 7 days is displayed
(evening: 18:00–20:00).
Individual measured values
1. If you press M1/M2 again, the last individual measurement is displayed.
2. If you press M1/M2 again, you can view the individual measured values.
3. Press to switch the device o again.
Press to exit the menu.
Deleting measured values
1. To delete all of a user's measured values, select the corresponding user.
Start the retrieval of the average measured values.
the average value of all this user's saved measured values is displayed.
2. Press and hold the memory button M1 or M2 for 5 seconds depending on
the user memory you are in.
)
appears on the display. All this user's values are deleted.
Deleting individual measurements
1. To clear individual measurements from the relevant user memory, you must
first select a user memory.
2. Start the retrieval of the individual measured values.
3. Press and hold the memory button M1 or M2 for 5 seconds (depending on
the user memory you are in).
4. The selected value is deleted. The device briefly displays
5. If you would like to delete other values, repeat the process described above.
You can switch o the device at any time by pressing the START/STOP
button .
28
flashes on the display,
.