Beurer BM 54 Mode D'emploi page 26

• Only use the device with the cu supplied, based on your upper arm cir-
cumference.
• Before taking the measurement, check the fit using the index mark de-
scribed below.
• Expose your upper arm. The circulation of the arm must not be hindered
by tight clothing or similar.
• The cu must be placed on the upper arm so that the bottom edge is po-
sitioned 2-3 cm above the elbow and over the artery. The line should point
to the centre of the palm here
The cu should be fastened so that two fingers fit under the cu when it
is closed .
C
• Now insert the cu line into the connection for the cu connector.
• The cu is suitable for you if the index mark
after fitting the cu .
Adopting the correct posture
• Sit in a comfortable upright position when taking the blood pressure meas-
urement. Lean back so that your back is supported.
• Place your arm on a surface
• Place your feet flat on the ground next to one another.
• The cu must be level with your heart.
• Stay as still as possible during the measurement and do not talk.
Selecting the user
This device can have up to 2 users with 60 memory spaces each, allowing you
to separately save measurements from 2 di erent people.
If multiple people are using the device, make sure that the correct user has been
selected before each measurement:
• Using the memory button M1 or M2, select the desired user memory
( ) when the device is switched o .
.
B
is within the OK range
.
D
• If you do not select a user memory, the measurement is stored in the most
recently used user memory. The relevant symbol
display.
• Press the START/STOP button
The measurement is then stored in the selected user memory. If you forget
to turn o the device, it will switch o automatically after approx. 3 minutes.
In this case too, the value is stored in the selected or most recently used
user memory.
6.3 Taking a blood pressure measurement
Requirement: cu attached, user selected.
Measurement
1. Press . All display elements are briefly displayed. The cu inflates itself
automatically. The measurement process starts.
a pulse is detected.
To cancel the measurement, press
2. The systolic pressure, diastolic pressure and pulse measurements are dis-
played.
"Er_" is displayed if the measurement could not be performed properly. In
this case, please refer to the "Troubleshooting" section.
If necessary, re-attach the cu after 1 minute.
The device switches o automatically after approx. 1 minute. The value is
saved to the selected or most recently used user.
26
or appears in the
to switch o the blood pressure monitor.
is displayed as soon as
.