Connecting The Flight Battery - Reely Beginner Falcon V2 Notice D'emploi

d) Connecting the Flight Battery
Move the control stick for the pitch and tail functions
(also see figure 1, item 14) to the bottom position and
switch on the transmitter.
Observe the correct position of the toggle switch for the
motor off function (also see figure 1, item 17). It must be
in the rear position „1" (control stick points to the body)
so that the drive motor of the helicopter cannot start up.
The toggle switch for the 3D-setting (also see figure 1,
item 4) must be in the front position „0" for this.
Then connect the T-plug connector of the fight controller
(1) that is protected against polarity reversal to the T-
plug connector of the flight battery (2).
Right after the rechargeable battery connection, the lin-
kage levers of the three swash plate servos (3) move
into the position specified by the transmitter and the gyro
performs an internal reconciliation. During this time, the
LED of the gyro (4) will flash.
Important!
While the gyro performs its reconciliation, the
helicopter must not be turned or moved.
When the reconciliation is completed, the linkage rod of
the tail servo (5) will also run into the specified position
(right angle to the linkage rod) and depending on opera-
ting mode of the gyro, the LED at the gyro (4) goes out
or remains lit permanently.
When the rechargeable battery is connected to the
model helicopter, the swash plate must be horizontally
aligned (see middle image in figure 13) and must not
be tilted.
If the swash plate is slightly tilted, use the trim or twist
the linkage rods to adjust the swash plate precisely.
For further information on this, see the following chap-
ters „Trimming the Model Helicopter" and „Fine-Tuning
the Model Helicopter".
72
Figure 13