Maintenance And Care; Checking The Screw Connections - Reely Beginner Falcon V2 Notice D'emploi

20.

Maintenance and Care

Clean the exterior of the model and the remote control only with a soft, dry cloth or a brush. Never use abrasive clea-
ning agents or chemical solutions as these could damage the surfaces of the plastic parts.
All moving parts have to be easily movable but there should not be a clearance in the bearing. The motor shaft with
the rotor shafts must be aligned perfectly straight and must not be eccentric.
The spare parts list is located on our website www.conrad.com in the download section for the respective
product.
You can also order the replacement parts list by phone. For the contact data, please refer to the top of these
instructions in the chapter „Introduction".
a) Checking the Screw Connections
Regularly check all screw connections of your helicopter
for tight fit.
Particularly observe the adjustment ring screws (1) at
the rotor shaft.
Figure 35
95