Rizzoli ST Série Manuel D'utilisation page 127

4.2 PLACEMENT OF THE THERMAL COOKER
The pipes connecting the boiler of the ther-
mal cooker and the kit are in the rear side of
the device and have a protrusion of about 5
cm from the stainless steel frame. To make
the installation in adhesion to the rear wall,
it is included an extension of the top able
to fill the gap from the top and the wall. In
4.3 UNFIXING THE COVER OF THE KIT (STK)
Before making the hydraulic connections, it
is necessary to unfix the covering structure
of the kit. In particular, the little top must
be unfixed: release the screws and then un-
A
2
C
Picture 25 - Unfixing the cover of the kit
1
125
this way, the depth of the top of the device
increases from 60 to 65 cm.
Otherwise, we suggest to predispose a niche
in the wall in correspondence of the pipes.
In this way, the pipes can suit the wall thick-
ness and so it is possible to install the cooker
in adherence without increasing its depth.
thread it upwards. Then, unfix the side re-
moving the two blocks of green electric con-
nectors of the control unit: finally, unhook it
and lift it from the plinth.
B
D