Rizzoli RTE Série Manuel D'utilisation page 111

RTE 80 - RTE 90 - RTVE 80 - RTVE 90
Picture 8 – Multiflue thermal cooker with oven, predisposition of the correct flue outlet. In the example, ther-
mal cooker with right flue outlet. The left flue outlet is symmetrical.
2.9 CORRECT CONJUNCTION TO THE CHIMNEY
If the conduct of the chimney starts from a low-
er floor than the connection point of the thermal
cooker, it may be necessary to close the conduct
under the connection pipe with fireproof materi-
als. If you have the chimney behind or up, you have
to use the connector with bayonet coupling. This
Picture 9 - Tolerance for flue outlet on the top and back. The tolerance depends on the orientation of the
connector.
If you have a lateral chimney in correspondence
of a side, the connector is sliding. To install it cor-
rectly, it is necessary to remove the cooking plate.
Now, the connector must be completely inserted
inside the wood fired thermal cooker or the chim-
ney, keeping the fixing buttonhole on the same
must be inserted and turned so that it can remain
blocked. This connector has a tolerance of about 1
cm to make the installation easier. The tolerance
is available according to a single direction which
depends on the orientation of the connector (see
picture 9).
Y
+/-
10 mm
side of the thermal cooker. Then, you can place
the wood fired thermal cooker, extract correctly
the connector so that it connect the thermal cook-
er with the chimney. Finally, bend the buttonhole
and block the parts with the screw-lock (see pic-
ture 10).
109
X
+/-
10 mm