Publicité
Les langues disponibles
Les langues disponibles
• Refuel outdoors only and do not smoke while refu-
elling.
• Before refuelling, switch off the combustion engine
and let it cool down.
• Petrol must be filled before starting the combustion
engine. While the combustion engine runs or if the
machine is hot, the tank plug must not be opened
and petrol must not be filled.
• Open the tank plug carefully and slowly. Wait for the
pressure to equalise and only then remove the tank
cover completely.
• Use a suitable funnel or filler pipe for refuelling so
that no fuel can spill onto the combustion engine and
housing or lawn.
Do not overfill the fuel tank!
• To leave room for the fuel to expand, never fill the
fuel tank beyond the lower edge of the filling nozzle.
Observe additional information in the combustion
engine user manual.
• If petrol has overflowed, do not start the combustion
engine until the petrol-contaminated area has been
cleaned. Avoid starting the engine until the fuel va-
pours have evaporated (wipe dry).
• Always wipe up spilled fuel immediately.
• If petrol has got on clothing, it must be changed.
• The tank cover must be properly screwed on and
tightened after each refuelling operation. The device
must not be put into operation without the original
tank cover screwed on.
• For safety reasons, check fuel line, fuel tank, tank
plug and connections regularly for damage, ageing
(brittleness), tight fit and leaks and replace if nec-
essary.
• Only empty the tank outdoors.
• Never use beverage bottles or similar to dispose of
or store operating materials, such as fuel. People,
especially children, could be tempted to drink from it.
• Never store the device with petrol in the tank inside
a building. Any fuel vapours produced can come into
contact with naked flames or sparks and ignite.
• Do not place the device and fuel tank near heaters,
radiant heaters, welding machines or other sources
of heat.
Risk of explosion!
If a defect is detected on the tank, the tank cover or
on fuel-carrying parts (fuel lines) during operation, the
combustion engine must be switched off immediately.
Then consult a specialist dealer.
6. Technical data
Power generator
Protection category
Continuous output P
(230 V) (S1)
Max. power P
(S2 5min)
Rated voltage U
Rated current I
Rated current I
Frequency F
Performance class
Active power factor φ
Quality class
Drive motor type
Displacement
Max. power (engine)
Fuel
Tank contents
Engine oil type
Oil volume (approx.)
Consumption at full load
Weight
Max. temperature.
Max. altitude (above mean
sea level)
Spark plug
Technical changes reserved!
Operating mode S1 (continuous operation)
The machine may be operated continuously with the
specified power.
Operating mode S2 (short-term operation)
The machine may only be operated at maximum power
for a brief time.
Information about the noise level measured in accord-
ance with applicable standards (EN ISO 3744:1995,
ISO 8528-10:1998):
Sound pressure L
Sound pressure L
Measurement uncertainty K
Wear hearing protection.
Excessive noise can result in a loss of hearing.
www.scheppach.com
(COP)
n
(230 V)
max
n
n
2 x 2.1 A (USB)
n
n
4-stroke 1 cylinder
Super E10 petrol
pA
wA
pA
Digital inverter
IP23M
1.6 kW
2.0 kW
2 x 230 V
~
7 A (230 V
)
~
50 Hz
G1
1
A
air-cooled
79 cm
3
2.2 kW / 3 HP
4.1 l
15W40
350 ml
1.27 l/h
17.5 kg
40
C
°
1000 m
A7RTC
71.6 dB
91.6 dB
1.13 dB
GB | 29
Publicité
