Publicité
Les langues disponibles
Les langues disponibles
English
To adjust the position of the control handle:
► Shut off the engine, @ 12.
1
► Open the clamping lever (1).
► Move the control handle (2) to the most comfortable
position.
► Close the clamping lever (1).
9.2
Adjusting the Blower Tube
To adjust the blower tube (BR 700 only):
1
2
► Loosen the union nut (1).
► Pull the blower tube (2) out to the required length.
► Tighten the union nut (1).
18
9.3
Putting on the Harness
WARNING
The operator must be able to remove the blower quickly in
the event of an emergency. In an emergency, open and
2
remove the chest strap quickly before dropping the blower to
the ground.
To ensure a proper fit:
► Put the blower on your back.
► Adjust the harness straps (1) so that the backplate fits
snugly and securely against your back.
► Always wear the blower harness over both shoulders.
► To remove the harness, loosen the harness straps by
lifting the sliding adjusters.
To help reduce the risk of injury in the event of an
emergency, practice quickly opening the shoulder straps
and removing the blower.
NOTICE
To avoid damage, ease the blower to the ground when
practicing. Do not allow the blower to drop to the ground and
do not throw it.
9 Adjusting the Blower
1
0458-459-8221-C
Publicité
