Struers Unitom-50 Manuel D'instructions page 42

Maintenance of Cutting Tables
Maintenance of Cut-off Wheels
Storing of Bakelite Bonded Al
Cut-off Wheels
Maintenance of Diamond and
CBN Cut-off Wheels
Maintenance of
Clamping Devices
38
Unitom-50
Instruction Manual
The iron rails (available as spare parts) should be replaced if they
have become worn or damaged.
O
These cut-off wheels are sensitive to humidity. Therefore, do not
2 3
mix new, dry cut-off wheels with used humid ones. Store the cut-
off wheels in a dry place, horizontally on a plane support.
The precision of diamond and CBN cut-off wheels (and thus the
cut) depends on how carefully the following instructions are
observed:
Never expose the cut-off wheel to overload, such as heavy
mechanical load, or heat.
Store the cut-off wheel in a dry place, horizontally on a plane
support, preferably under light pressure.
A clean and dry cut-off wheel does not corrode. Therefore, clean
and dry the cut-off wheel before storing. If possible, use
ordinary detergents for the cleaning.
It is recommended to thoroughly clean and lubricate the
Quick Clamping Device and Vertical Clamping Device at regular intervals.
Important