Struers Unitom-50 Manuel D'instructions page 29

Using Fixed Stop
Using Fixed Stop
together with Autostop
Setting the Stop Position
Unitom-50
Instruction Manual
Fixed stop can be used together with the AutoStop On function. In
this situation, the cutting stops at the first occurring stop signal.
To ensure that the cutting is not stopped before a certain position,
AutoStop should be set to AutoStop Off in the configuration, using
fixed stop only.
Clamp the workpiece so that the cut-off wheel can be moved
along the workpiece.
Press POSITION DOWN
along the workpiece, to the desired stop position. Remember to
take the wear of the cut-off wheel into consideration.
Press F3: ACT. to record the actual stop position. The stop
position is now set to the desired position.
Move the cut-off wheel back into top position, and clamp the
workpiece correctly.
V
to move the cut-off wheel down,
25