Struers Unitom-50 Manuel D'instructions page 6

Checking the Contents
of Packing
Recirculation Cooling Unit
Placing Unitom-50
Placing Unitom-50 on a table
other than LABUL
2
Unitom-50
Instruction Manual
1. Getting Started
In the packing box you should find the following parts:
1 Fork spanner 30 mm, for changing the cut-off wheel
1 Grease gun, for lubrication of tilting frame bearings and
oscillating table.
2 Cover plugs for threads for cutting tables
1 Set of Instruction Manuals
1 PVC hose 1/2", 2 m
1 Outlet hose, 2 m
1 Drain elbow pipe, 15°
5 Hose clamps
The kit also contains the below parts exclusively for Unitom-2/-5
1 38 mm drain hose
1 87° elbow drain fitting
1 32-50 mm hose clamp
Unitom-50 should be placed on the optional Struers table
(LABUL), or a table that is able to carry a weight of min. 200 kg.
Adjust the table height using the screws in the table legs. It is
important that both the table and Unitom-50 are level. Place
Unitom-50 on the table. If the machine is not level, adjust the
height for each corner, as follows:
Loosen the upper 13 mm nut under the corner screw.
Adjust the lower 8 mm nut with a spanner.
Re-fasten the upper 13 mm nut again.
Repeat the adjustment for each of the other three corners until
Unitom-50 is levelled.
A 65 mm hole must be drilled in the base of the table for
attachment of the outlet hose.
(see drawing 15317049 in the Spare Parts manual).