Visualisations For The User - AERMEC Omnia UL 11 N Manuel D'utilisation Et D'installation

INDICATOR LIGHTS FOR THE USER (STANDARD CONFIGURATION)
LED D indicates a ventilation request:
YELLOW - (ON) The ambient conditions require the use of the fan (when the speed
selector is on AUTO, V1, V2, V3)
- (OFF) The ambient conditions do not require the use of the fan, or the
selector is in the OFF (standby) position, or the fin is closed
- (slow flashing) Operation mode managed by the centralised system. The
fan selector on the panel is automatically blocked.
- (quick flashing) Indicates an ambient probe fault
(contact the After Sales Service)
LED C indicates the active operating mode:
RED - Heating
- Quick flashing indicates that the Anti-freeze (Frost Protection) function is active
RED + FUCHSIA - Heating. The alternate flashing colours indicate the absence of suitable
conditions for enabling ventilation (unsuitable water temperature, or
closed fin on versions with motorised fin).
BLUE - Cooling
BLUE + FUCHSIA - Cooling. The alternate flashing colours indicate the absence of suitable
conditions for enabling ventilation (unsuitable water temperature, or
closed fin on versions with motorised fin).
Special visualisations following particular operating conditions:
(these visualisations can be interpreted by the After Sales Service)
BLUE + YELLOW - Slow flashing of the BLUE LED (C) and the YELLOW LED (D).
Addressing procedure in progress. Turn the ventilation speed selector knob
to activate the automatic procedure to assign the address to the unit.
The thermostat functions are temporarily disabled.
FUCHSIA + BLUE + RED Visualisation of the unit's serial address
- The number of flashes of the FUCHSIA LED indicates the units.
- The number of flashes of the BLUE LED indicates the tens.
- The number of flashes of the RED LED indicates the hundreds.
FUCHSIA + YELLOW - Slow contemporary flashing of the YELLOW LED and the FUCHSIA LED
indicates the absence of communication between the control panel and the
thermostat.
SET POINT - AN EXAMPLE OF A SETTING
Set Point
IULNIJ 1711 - 4528500_01
D
C
AUX
27