Important Information • Package; During Operation - AERMEC Omnia UL 11 N Manuel D'utilisation Et D'installation

IMPORTANT INFORMATION
WARNING: OMNIA fan coils
are designed for indoor use.
WARNING: the fan coil is con-
nected to power supply and
water circuit. Operations per-
formed by persons without the
required technical skills can lead
to personal injury to the operator
or damage to the unit and sur-
rounding objects.
WARNING: components sensi-
tive to static electricity may be
destroyed by discharge notably
lower than those at the human
perception threshold. These dis-
charges form when you touch a
component or electric contact of
a unit, without first discharging
accumulated static electricity
from your body. The damage
caused to the unit by an overvolt-
age is not immediately evident - it
only appears after a certain peri-
od of operation.
STATIC ELECTRICITY ACCUMULATION
Any person not connected in a con-
ductive manner with the electronic
potential of his surrounding envi-
ronment can accumulate electro-
static charges.
STANDARD PROTECTION AGAINST
ELECTROSTATIC CHARGES
Earthing quality
When working with units sensi-
tive to electrostatic electricity,
ensure that people, workplaces
and unit casings are correctly
earthed. This will prevent the for-
mation of electrostatic charges.
Avoid direct contact
Only touch the element exposed
to electrostatic risk when abso-
lutely essential (e.g. for mainte-
nance).
Touch the element without com-
ing into contact with either the
contact pins or the wire guides. If
PACKAGE
The fan coils are shipped in stan-
dard package which consists of
you follow this rule, the energy
of the electrostatic charges can-
not reach or damage the sensitive
parts.
Before taking measurements on the
unit, it is necessary to discharge
all electrostatic charges from your
body: to do this, just touch an
earthed metal object. Only use
earthed measuring instruments.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
DO NOT USE THE FAN COIL
IMPROPERLY
Do not use the fan coil for ani-
mal husbandry applications (e.g.
incubation).
AIR THE ROOM
Periodically air the room in which
the fan coil has been installed. This
is particularly important if the room
is occupied by many people, or if
gas appliances or sources of odours
are present.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be
adjusted in order to provide maxi-
mum comfort to the people in the
room, especially if they are elderly,
children or sick people; avoid dif-
ferences over 7°C between the out-
door temperature and the tempera-
ture inside the room in summer.
In summer, a temperature that is too
low causes higher electrical con-
sumption.
CORRECTLY ADJUST THE AIR JET
Air coming out from the fan coil
must not reach people directly; in
fact, even if the air is warmer than
the room temperature, it could
cause a cold sensation and result
in discomfort.

DURING OPERATION

Always leave the filter fitted on
the fan coil during operation
expanded polystyrene foam and
cardboard shells.
(otherwise dust in the air could
soil the coil surface area).
WHAT IS NORMAL
In the cooling operation, water
vapour may be present in the air
delivery of the fan coil.
In the heating operation, a slight
hiss might be heard close to the
fan coil. Sometimes the fan coil
might give off unpleasant smells
due to the accumulation of sub-
stances present in the air of the
room (clean the filter more often,
especially if the room is not venti-
lated regularly).
While the unit is functioning, there
could be noises and creaks inside
the device due to the various ther-
mal expansions of the elements
(plastic and metal), but this does
not indicate any malfunction and
does not damage the unit unless
the maximum input water temper-
ature is exceeded.
MALFUNCTIONING
In the event of a malfunction, cut
off power supply to the unit, then
restore the power and start the
unit again. If the problem occurs
again, call the local After-Sales
Service immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull,
tread on or crush the electric
power cable, or fix it with nails or
drawing pins.
A damaged power cable can
cause short circuits and injure
people.
DO NOT OBSTRUCT THE AIR
O U T L E T S
OBJECTS INTO THEM
Do not put anything in the air out-
let slots.
This could injure people and dam-
age the fan.
IULNIJ 1711 - 4528500_01
B Y P L A C I N G
23