Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UNIT INSTALLATION
- Loosen the screws to remove the housing.
- With wall-mounted units, keep a
minimum clearance of 80mm from
the floor. With floor-standing units on
feet, refer to the instructions supplied
with the accessory.
- The supporting wall must be perfectly
flat. For fixing, use 4 wall plugs (not
INSTALLATION EXAMPLES
UL_N
wall-mounted installation
COIL ROTATION
If the hydraulic connections require
the rotation of the coil, remove the
cabinet and ambient probe then
proceed as follows:
– remove the electrical connections
from the terminal strip;
– remove the probe from the coil;
– remove the screws fixing the basin
and remove it;
– remove the screws securing the coil,
then remove the coil;
– remove the push-outs on the right-
hand side;
– rotate the coil and secure it with the
previously removed screws;
– reassemble the tray, fixing it with the
screws. All the trays are suitable for
34
IULNIJ 1711 - 4528500_01
supplied) with suitable characteristics
for the specific type of wall.
- Apply any accessories.
- To m o d i f y t h e s e t t i n g s o f t h e
electronic thermostat, adjust the dip-
switches from the special inspection
window in the box on the side (see
"DIP-SWITCH SETTINGS").
UL_N
wall-mounted installation with feet (ZU)
condensate drainage on both sides;
NB: before connecting the condensate
discharge, use a tool to knock out the
diaphragm of the tray on the water
connections side.
– position the polyethylene cap of the
condensate discharge onto the left-
hand side;
– remove the electric motor cable from
the right-hand side;
– remove the rectangular push-out from
the left-hand side;
– recover the cable grommet and insert it
in the left-hand side before closing the
right-hand hole with adhesive tape;
– move the electric motor cable onto
the left-hand side, passing it through
- Make all the connections.
- Reassemble the casing.
- Make sure the fan coil is working properly.
- Assemble the air filter. It is supplied in
a sealed box, to be opened only at the
time of use.
UL_N
ceiling installation
the cable grommet and arranging it so
it reaches the connector on the side;
– move the control panel from the right
to the left of the head (the hole must be
closed with the recovered plastic baffle);
– unravel the twists and turns of the
microswitch cable for the length
necessary to reach the control board
on the left-hand side;
– fasten the microswitch cable to the
cable clamps;
– restore the electrical wirings between
the control panel and control board.
Publicité
Chapitres
Table des Matières
