MIRKA AOS-B 130 Manuel D'utilisation page 67

Troubleshooting guide
Symptom
No light from sander right LED when
trigger is pressed.
The sander LED (right) is red and the
sander slows down to 4,000 rpm
when sanding.
The sander LED (right) is red and
rpm is slightly reduced.
The left LED is red and the sander is
not running.
Disposal information
DANGER
Render redundant power tools unusable by removing the power cord.
Observe applicable country-specific regulations regarding disposal and recycling of disused machines,
packaging and accessories.
EU only: Do not dispose electric power tools in house-hold waste. According to European Directives
on waste electrical and electronic equipment and its implementation under national law, electric
tools that have reached the end of their life must be collected separately and taken to an environ-
mentally compatible recycling facility.
For more information regarding REACH, RoHS and our corporate social responsibility visit
www.mirka.com
Possible cause
Battery pack not properly attached to
the sander.
Battery totally empty.
Temperature too high in the sander.
Too heavy long term load.
Too heavy short term load.
The battery voltage is too low.
Solution
Insert the battery properly.
Charge the battery.
Reduce the load on the sander for
some time and the sander will speed
up again.
Use lighter load and the LED (right)
will automatically change to green.
Charge the battery.
Mirka® AOS-B 130 & AROS-B 150
en (original)
67