MIRKA AOS-B 130 Manuel D'utilisation page 65

NOTE! This charger can only charge Mirka 12V battery packs.
NOTE! Charging times may be longer depending on the surrounding temperature and battery conditions.
LED indication of BCA 108 charger
Charger diagnostics
The charger will indicate if:
A battery pack is overheated. All three charging lights will flash. Remove the battery and allow it to cool down for 15 30
minutes and re-insert.
A malfunction occurs in the battery or the charger. Two charging lights will flash. Remove the battery and allow it to
cool down. Re-insert the battery pack into the charger. If two charging lights still flash, the battery or charger may
require service.
How to get started
1. When unpacking the tool, make sure it is intact, complete and has not been damaged in transport. Never use a
damaged tool.
2. Before use, check that the backing pad is correctly mounted.
3. Install the fully charged battery pack into the sander until it locks in place with a click.
Operating instructions
The tool is intended to be operated as a hand held tool. The tool can be used in any position.
Select a suitable abrasive and secure it to the backing pad. Make sure the abrasive is centered on the backing pad.
The sander can now be activated / turned on and started by pressing the switch trigger.
The sander will run and stay in active mode as long as the trigger is pressed. After the trigger is released the sander will
stop but continue to stay in active mode for a short time before it automatically deactivates / turns off.
When sander is in active mode the right LED is green.
In active mode the left LED shows the battery status:
Green: Battery charge level is OK.
Flashing green/red: Battery charge level is weak.
Red: Battery voltage too low. Sander is not operable.
In active mode the max rpm can be adjusted by pressing rpm+ or rpm , see Figure 1.
The rpm can be adjusted in steps of 4 000, 5 000, 6 000, 6 500, 7 000, 7 500 and 8 000 rpm.
The rpm can be locked to prevent an accidental rpm change. Wait until the sander is not in active mode. Simultaneously
press and hold both rpm+ and rpm buttons and then pull the switch trigger. In order to unlock the tool, repeat same
operation. If rpm+ or rpm is pressed in speed lock mode the right led flashes red twice but no speed change occur.
When sanding, always place the tool on the work surface before starting the tool. Always remove the tool from the
work surface before stopping it. This will prevent gouging of the work surface due to excess speed of the abrasive.
AOS-B 130 & AROS-B 150
en (original)
Mirka® AOS-B 130 & AROS-B 150
65