MIRKA AOS-B 130 Manuel D'utilisation page 266

en | us-ca
Do not allow any liquid to get inside charger. Electric shock may result.
This charger is not intended for any uses other than charging rechargeable batteries.
Do not place any object on top of the charger, near any heat source or place the charger on a soft surface that may
result in excessive internal heat.
Make sure the cord is located so it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
Do not use the charger if it has received a sharp blow, been dropped or otherwise damaged in any way.
Do not store or use the tool and battery pack in locations where the temperature may reach or exceed 50 °C (122 °F).
The charger is designed to operate on standard household electrical power (100 240 VAC). Do not attempt to use it
on any other voltage.
Children should be supervised to ensure that they do not play with the appliance
Additional Safety Warnings
Always ensure that the work piece to be sanded is firmly fixed in place.
Always remove battery during any transportation of the tool.
Do not allow the tool to free speed without taking precautions to protect surrounding people and objects in the event
that the abrasive or backing pad should come loose.
Read all instructions before using this tool. All operators must be fully trained in the proper, safe use of this tool.
All maintenance must be carried out by trained personnel. For service, contact a Mirka authorized service center.
If the tool appears to malfunction, stop using it immediately and arrange for service and repair.
Before changing the abrasive always disconnect the power source
Never carry, store or leave the tool unattended with the power source connected.
Keep hands clear of the spinning pad during use.
Always wear required personal safety protection in accordance with manufacturer s instructions and local/national
standards while using this tool.
Read the Materials Safety Data Sheet (MSDS) for the working surface.
If any physical hand/wrist discomfort is experienced, stop working and seek medical attention. Hand, wrist and arm
injury may result from repetitive work, motion and overexposure to vibrations.
Additional information on battery and charger
Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks,
immediately discontinue use and do not recharge.
Technical data
®
Mirka AOS-B 130
Voltage 12 VDC
Speed 4000 8000 rpm
Orbit 3 mm (1/8")
Size of backing Ø 32 mm (1 1/4")
pad
Weight (incl. bat- 0.57 kg (1.3 lbs)
tery)
Battery charger
Input
Charging time
Storage temperature
range
Charging temperature
Dimension
Weight
266
Mirka® AOS-B 130 & AROS-B 150
Mirka BCA 108
120 VAC, 60 Hz
< 50 min (2.5 Ah)
< 100 min (5.0 Ah)
-20 °C 80 °C (-4 °F 176 °F)
4 °C 40 °C (39 °F 104 °F)
191 x 102 x 86 mm
(7 1/2 x 4 x 3 3/8")
0.66 kg (1.5 lbs)
AROS-B 150
12 VDC
4000 8000 rpm
5 mm (3/16")
Ø 32 mm (1 1/4")
0.56 kg (1.2 lbs)