Publicité
Les langues disponibles
Les langues disponibles
en (original)
When sanding is finished, remove the battery from the sander by simultaneously pressing the button on both sides
and removing the battery from the tool. Charge the battery.
Bluetooth
This tool is equipped with Bluetooth® low energy technology and can be connected to MyMirka app through which
additional tool functionality can be accessed. For more information on the app functionality and if it is available in your
country, go to www.mirka.com/mymirka
Activate Bluetooth on your Mirka
1.
Connect the battery to the tool.
2.
Press and hold the rpm+ button while activating the tool by pressing the switch trigger.
3.
Middle LED is flashing green, to indicate that Bluetooth is active and ready for connections.
4.
Middle LED is lit green when the tool is connected to another Bluetooth device.
5.
Bluetooth is deactivated when the tool is deactivated/turned off.
NOTE! If the app is not installed or if it is not available in your country, Bluetooth shall not be activated.
The Bluetooth
®
word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc. and any use of such
marks by Mirka Ltd is under license. Other trademarks and trade names are those of their respective owners.
Maintenance
Always remove the battery before maintenance!
Only use original Mirka spare parts!
Replacing the backing pad
1.
Hold the spindle with your fingers.
2.
Turn the backing pad counterclockwise to remove it.
3.
Fit and tighten the new backing pad.
Cleaning
Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes while cleaning.
If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other cleaning agent. Never use caustic agents to clean plastic parts.
Charger cleaning instructions
Dirt and grease may be removed from the exterior of the charger using a cloth or soft non metallic brush. Do not use
water or any cleaning solutions.
Further service
Servicing must always be performed by trained personnel. To keep the tool warranty valid and ensure optimal tool safety
and function, servicing must be carried out by a Mirka authorized service centre. To locate your local Mirka authorized
service centre, contact Mirka Customer Service, your Mirka dealer or go to www.mirka.com
66
Mirka® AOS-B 130 & AROS-B 150
®
AOS-B 130 & AROS-B 150 as follows:
AOS-B 130 & AROS-B 150
Publicité
