MIRKA AOS-B 130 Manuel D'utilisation page 268

en | us-ca
Store and charge your battery in a cool area. Temperatures above or below normal room temperature will shorten
battery life.
Never store the battery in a discharged condition. Recharge it immediately after it has been discharged.
All batteries gradually lose their charge. The higher the temperature, the quicker they lose their charge.
If you store your tool for long periods of time without use, recharge the battery every month. This practice will prolong
battery life.
Charging procedure
Connect the power cord to the charger, and then plug into an outlet before inserting battery pack. All three charging
lights will be on for two seconds and then turn off.
Insert the battery pack into the charger. The lights will start to flash within 30 seconds.
During the charging process, the charging lights will indicate the status as follows:
Three charging lights will flash in sequence during the charging process.
Fully charged, all three lights will remain on continuously.
The charging process will last approximately 50 minutes for BPA 10825/11125 and 100 minutes for BPA 10850/11150
battery pack.
NOTE! This charger can only charge Mirka 12V battery packs.
NOTE! Charging times may be longer depending on the surrounding temperature and battery conditions.
LED indication of BCA 108 charger
Charger diagnostics
The charger will indicate if:
A battery pack is overheated. All three charging lights will flash. Remove the battery and allow it to cool down for 15 30
minutes and re-insert.
A malfunction occurs in the battery or the charger. Two charging lights will flash. Remove the battery and allow it to
cool down. Re-insert the battery pack into the charger. If two charging lights still flash, the battery or charger may
require service.
How to get started
When unpacking the tool, make sure it is intact, complete and has not been damaged in transport. Never use a
1.
damaged tool.
2. Before use, check that the backing pad is correctly mounted.
Install the fully charged battery pack into the sander until it locks in place with a click.
3.
Operating instructions
The tool is intended to be operated as a hand held tool. The tool can be used in any position.
Select a suitable abrasive and secure it to the backing pad. Make sure the abrasive is centered on the backing pad.
268
Mirka® AOS-B 130 & AROS-B 150