Publicité
Les langues disponibles
Les langues disponibles
Beam setting (fig. 61)
When checking beam setting, put the motorcycle
upright. Tyres should be inflated at the correct pressure
and one person should be sitting astride the motorcycle,
keeping it at right angles to its longitudinal axis. Place the
motorcycle opposite a wall or a screen, 10 meters apart
from it, then draw a horizontal line dictated by headlamp
centre and a vertical one in line with the longitudinal axis
of motorcycle.
E
If possible, perform this check in dim light.
Switch on the low beam. The height of the light spot
(measured at the upper limit between dark and lighted-
up area) should not exceed 9/10
ground of headlamp centre.
Note
The procedure described here is in compliance
with the "Italian Standard" establishing the maximum
height of the light beam. Owners in other countries will
adapt said procedure to the provisions in force in their
countries.
60
th
of the height from
9
x
10
10 m
fig. 61
x
Publicité
