Publicité
Les langues disponibles
Les langues disponibles
Starting the engine
Note
Follow the "High ambient temperature" procedure
to start the engine when it is warm.
Warning
Before starting the engine, become familiar with
the controls you will need to use when riding.
Regular ambient temperature
(10 °C/50 °F to 35 °C/95 °F):
1) Move the ignition key to ON (fig. 29). Make sure both
the green light N and the red light
instrument panel come on.
Important
The oil pressure light should go out a few seconds
after the engine has started (page 11).
Warning
The side stand must be fully up (in a horizontal
position) as its safety sensor prevents engine start when
down.
Note
It is possible to start the engine with side stand
down and the gearbox in neutral. When starting the bike
with a gear engaged, pull the clutch lever (in this case the
side stand must be up).
2) Move the cold start lever to the B position (fig. 30.1-
32.2).
3) Check that the stop switch (1, fig. 31.1-31.2) is
positioned to
(2).
This model is equipped with a servoignition system.
To achieve assisted engine starting, press the button (2)
and release it immediately.
Pressing the button (2) operates automatic engine
starting for a maximum period of time that varies
depending on engine temperature.
When the engine has started, the system prevents the
starter motor from turning over.
on the
If the engine fails to start, allow at least 2 seconds before
pressing the starter button (2) again.
(RUN), then press the starter button
E
ON
fig. 29
37
Publicité
