Saving Torque And Speed Data; Changing The Contra-Angle - B.A. International Powersurge LED Manuel D'utilisation

6.5 Saving torque and speed data

The procedure to follow for saving « torque and speed data » is as follows :
Press the button
Press the button
Name the fi le and then validate.
Data « torques and speeds » are located in the index "ImplMotCurve".
A fi le called « name » is created during backup. « name » is corresponding to what you captured.
A fi le called « name.csv » is created there during backup, if the fi le already exists, an incremental fi le is added : "Name001.csv".
It is a text fi le format that can be imported into a spreadsheet (Microsoft Excel for example).
Those fi les can be directly imported into a spreadsheet.
Fig. 7
The following data are measured every 0.25 s :
TIME : display time (in ms) that passed since the device is switched on.
TORQUE : display torque in 1/100 of N.cm (or in 1/100 of % if the reduction ratio is different from 20:1).
SPEED : display motor speed, in rpm.
(Fig.8)
.png images format
of torque and speed (Fig.5, Rep.5)
Fig. 8
B.A.
6.6 Changing a contra-angle
This is the list of available contra-angles :
Press the icon for the reduction ratio for the active contra-angle
20:1
C
Note that the speed ranges at the exit of the tool are displayed to the side of the selected contra-angle.
(Fig.3, rep.8).
(Fig.6, rep.7).
are also created in the index « name », one fi le for each sequence where recording
is activated.
1:3 1:1
BA Powersurge
Premium
5:1 16:1 20:1 30:1 256:1
(Fig.3, rep.2).
15