Electromagnetic Compatibility - B.A. International Powersurge LED Manuel D'utilisation

22
Dysfunction
The tool is not turning.
No spray or low flow or
water tightness problem.
A red screen appears
indicating an error.

12. Electromagnetic compatibility

This product requires specific precautions with respect to electromagnetic compatibility. It must be
installed and fitted according to the instructions in the section « 4 – Connection / Installation » .
Some types of mobile telecommunications devices such as mobile phones can interfere with this product.
The separation distances recommended in this section must be followed.
This product must not be used near or on any other device. If this is unavoidable, one must check its proper operation
in the usage conditions prior to use.
The use of accessories other than those specified or sold by
or a reduction in the immunity for this product.
The Powersurge unit is intended to be used in the electromagnetic environment specified below. The customer or user of
the Powersurge unit must ensure that it is used in such an environment.
Emissions test
RF CISPR 11 emissions
Causes
w Incorrect insertion of the tool.
w Broken contra-angle.
w Blocked motor.
w The pump flow is 0% or is too weak.
w Incorrect installation of irrigation line.
w Irrigation line defective or jammed.
w The data returned by the motor is incorrect.
w There may be several reasons for this :
- contra-angle malfunction
- micromotor malfunction
- motor malfunction
B.A. INTERNATIONAL
Directives and manufacturer's declaration – Electromagnetic emissions
Compliance
Group 1
Solutions
w Check the installation of the tool.
w Change the contra-angle.
w Check the status of the motor.
w Adjust the flow of the pump from
the working screen or the pedal.
w Check the positioning of the line.
Check that the run of direction matches
the IN/ OUT indications shown on the
pump cabinet.
w Replace the irrigation line.
w Switch on the motor again.
w If the problem persists, note the error
number and return the contra-angle unit,
micromotor and motor to your after-sales
service centre.
as replacement parts, can result in increased emissions
Electromagnetic environment - directives
Powersurge
The unit uses RF energy only for its internal
functions. Consequently, its RF emissions are very low
and are not likely to cause interference to an electronic
machine nearby.