MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 33

SERVICE & MAINTENANCE
PROP REPLACEMENT
TOOLS AND RESOURCES REQUIRED
• 9/16" Open End Wrench
INSTALLATION
1
a. Disconnect the motor from all sources of power prior
to changing the Prop.
b. Hold the Prop and loosen the Prop Nut with a pliers
or a wrench.
c. Remove the Prop Nut and Prop Washer.
NOTICE: If the Drive Pin is sheared or broken, you
will need to hold the shaft stationary with a flat blade
screwdriver pressed into the slot on the end of the shaft
while you loosen the Prop Nut.
2
d. Turn the old Prop to horizontal and pull it straight off.
If Drive Pin falls out, push it back in.
CAUTION
If the Prop does not readily slide off, take care to not bend
the Armature Shaft while removing the Prop. Pull the Prop
evenly off the Armature Shaft.
3
e. Align the new Prop with the Drive Pin.
f. Install the Prop Washer and Prop Nut.
g. Tighten the Prop Nut 1/4 turn past snug at
25-35 inch-lbs.
CAUTION
Do not over-tighten as this can damage the Prop.
©2024 Johnson Outdoors Marine Electronics, Inc.
• Flat Blade Screwdriver
Drive Pin Drive Pin
Prop Washer Prop Washer
CAUTION
Disconnect the motor from the battery before beginning any
Prop work or maintenance.
Prop Nut Prop Nut
Prop Washer Prop Washer
Prop Prop
Armature Armature
Shaft Shaft
Prop Prop
Prop Nut Prop Nut
Prop Prop
Drive Pin Drive Pin
minnkota.johnsonoutdoors.com | 33