MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 10

INSTALLING THE RIPTIDE TERROVA
2
c. Remove the four sideplate screws using a #3 Phillips
Screwdriver. Two of these screws will be located on
each side of the mount.
d. Remove the Right Sideplate.
e. Swing the Left Sideplate out and away from the
Base Extrusion.
2e
3
f. Review the mounting considerations at the
beginning of the installation. Place the motor on the
bow of the boat at the intended mounting location,
as close to the centerline or keel as possible.
The motor can be installed on either the Port or
Starboard side of the boat, based on personal
preference. Check placement with the motor in the
stowed and deployed positions.
10 | minnkota.johnsonoutdoors.com
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
2c
2d
Port Port
Outboard Outboard
Inboard Inboard
Sideplate Screw Sideplate Screw
Right Sideplate Right Sideplate
Starboard Starboard
Bow Bow
Keel Keel
©2024 Johnson Outdoors Marine Electronics, Inc.