MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 32

INSTALLING AN EXTERNAL TRANSDUCER
INSTALLING AN EXTERNAL TRANSDUCER
An external transducer is not included with your trolling motor. An external transducer can be installed onto the motor.
1
a. Mount the External Transducer according to
directions provided with the transducer.
b. Leave enough slack in the Transducer Cable
between the Lower Unit and Control Head to allow
the motor to properly stow and deploy.
c. Use two tie wrap cables to secure the Transducer
Cable to the Shaft just above the Lower Unit and just
below the Control Head.
d. Run the Transducer Cable through the Coil Cord to
the power supply.
CAUTION
Failure to follow the recommended wire routing for the
Advanced GPS Navigation and External Transducer Cables
may cause damage to the product and void your product
warranty. Take care to test the length and placement of
cable to be sure that there is enough slack where needed
and that cables are free of being entangled in moving parts.
Routing the cables in any way other than directed may cause
damage to the cables by being pinched or severed.
32 | minnkota.johnsonoutdoors.com
Control Head Control Head
Coil Cord Coil Cord
Transducer Cable Transducer Cable
Tie Wrap Tie Wrap
Cable Cable
Slack Slack
Tie Wrap Cable Tie Wrap Cable
Lower Unit Lower Unit
External Transducer External Transducer
©2024 Johnson Outdoors Marine Electronics, Inc.