MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 11

4
ITEM(S) NEEDED
#4 x 6
g. When the motor is in the deployed position, make
sure that the Shaft is 1-1/2" out past the Gunwale of
the boat. The lower unit, when stowed and deployed
must not encounter any obstructions.
h. Check to be sure that the mount is level. Use the
Rubber Washers (Item #4) provided to create a level
surface if necessary.
NOTICE: The mounting surface for the Riptide Terrova
must be flat. Rubber Washers may be used to shim the
Base Extrusion flat before hardware is tightened.
5
i. With the motor at the intended mounting location,
take an Awl or similar tool and mark all six mounting
holes in the Base Extrusion.
j. Make sure the area under the mounting location is
clear to drill holes and install nuts and washers. Slide
the motor aside to drill the mounting holes.
k. Drill through the boat deck using a Drill and a 9/32"
Drill Bit on all six marked locations.
©2024 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RIPTIDE TERROVA
Gunwale Gunwale
Minimum Minimum
Drilling Locations Drilling Locations
Drilling Locations Drilling Locations
1-1/2" 1-1/2"
Shaft Shaft
Base Extrusion Base Extrusion
Outboard Outboard
minnkota.johnsonoutdoors.com | 11